Australian Communications Forum
Sign up Calendar Latest Topics
 
 
 


Reply
  Author   Comment  
fazail

Junior Member
Registered:
Posts: 4
Reply with quote  #1 
Dear all!
I have a NEC SV9100 PBX and SV9100 PCPRO but i am not familiar with them. so if any one has a sample configuration backup , will make me happy.
Thanks!
R4

Founder
Registered:
Posts: 193
Reply with quote  #2 
What are you looking for? Why not just download your own system? Or are you looking for a guide to configuring the system from scratch?
fazail

Junior Member
Registered:
Posts: 4
Reply with quote  #3 
Dear R4!
We Use SOFO IS3000, SELTA OFFICE in our existing system, We want to have a configuration backup so we bring changes in PCPRO SV9100 and go to site (dangerous) and upload it, cause we are not familiar with core configuration process of NEC SV9100. 
If you have any step by step configuration document including Numbering Plan and E1 routing (since our existing PABX are linked with E1), please send it to us, we will appreciate it.

best regards!
R4

Founder
Registered:
Posts: 193
Reply with quote  #4 
Ok so you have a network of systems and want to be able to re upload them if needed. You also say that the sites are dangerous to visit so why haven't you connected the systems to your data network to allow you to work on them without visiting site?

You would be far better off backing up your existing configurations so that you can modify them off site and then simply upload the changed config.

If you are not familiar with the configuration of these systems, I would recommend you get the Features and specification manual which details all the features and then leads you through the programming requirements. see here....

http://www.planttel.net/docs/SV9100-FeatSpecs.pdf
fazail

Junior Member
Registered:
Posts: 4
Reply with quote  #5 
We do have the network, connected using SDH, which is the problem, if we install NEC in site it will disconnect the PABX route between 2 zones since we are not familier with it it will cost alot of time to remotely configure it. thats why we need something practical to work on it, a configuration with 2 E1 route to remote stations (A&C) for NEC SV9100 PABX in station B.
Which card is use for E1 carrier in PCPRO? it will solve most of our problems.
Capture.png 

R4

Founder
Registered:
Posts: 193
Reply with quote  #6 
Ok so I think I am beginning to understand what you want, I believe you have a network of Phillips Sopho pabxs and want to add an SV9100 linked to the other two systems by E1. This will not be easy if at all possible as I believe the SV9100 can only act as a slave so unless you can make both Sophos masters, it won't work. This has been asked before elsewhere, see here for example....

https://sundance-communications.com/forum/ubbthreads.php/topics/245989/E1_Qsig_for_SV8100

This is for an 8100 but the programming is pretty much identical. I believe the best option here is to get a qualified tech to set this up for you.
R4

Founder
Registered:
Posts: 193
Reply with quote  #7 
You may also want to try here....

https://www.tek-tips.com/threadminder.cfm?pid=937

Belvedere is a particularly knowledgeable poster.
Previous Topic | Next Topic
Print
Reply

Quick Navigation:

Easily create a Forum Website with Website Toolbox.